Factory Set Combination: 1 - 2 - 3 - 4 - 5 - 6

            

We recommend that you change your combination before you begin using your new gun safe. It is a simple process but must be executed exactly.

First, select a six (6) digit combination that you can easily remember and then follow the instructions below:

                  

STEP 1

      

Select a new six (6) digit combination that you can easily remember.

            

STEP 2

      

Enter your existing combination and open the door. Once open, extend the locking bolts completely so that the door remains open.

The door should always be open when you are changing combinations.

            

STEP 3

      

Enter in six (6) zeroes to enter programming mode. If done correctly, you will hear a double beep.

If you do not hear a double beep, leave the door open and start over at step 2.

            

STEP 4

      

Enter your existing six (6) digit combination. If done correctly, you will hear a double beep.

If you do not hear a double beep, leave the door open and start over at step 2.

            

STEP 5

      

Enter your newly selected six (6) digit combination. If done correctly, you will hear one single beep.

If you do not hear a single beep, leave the door open and start over at step 2.

            

STEP 6

      

Enter the new combination again to confirm your selection. If done correctly, you will hear one single beep.

If you do not hear a single beep, leave the door open and start over at step 2.

Wait ten seconds before moving on to the next step to allow your combination to permanently set.

            

STEP 7

      

Enter your new combination. If the procedure was executed properly, you will be able to rotate the handle.

If the gun safe will not open, the procedure was incorrectly executed. Your last combination will still be active. If you cannot rotate the handle, leave the door open and start over at step 2.

* If the door will not open after entering your combination or makes several beeps after entering the code, it is usually time for a battery change. A low battery is indicated by a yellow light.

If you enter your code and hear two beeps but no click, please change the battery.

If you enter you code and hear five beeps, please submit a ticket for a combination request.